What it does
The ILED-IG9 is a round inground uplight you set into the ground so it throws light up and out, washing a wall, a tree, a step, or open ground from below. It is not a side-lighting deck fitting; it is a central uplighter that lights the area around it. It comes in seven wattages, from a small 3W to a large 24W, so you size it to the surface. It is low voltage on the DC and low-AC options, and available on mains.
Seven sizes
The family runs in seven bodies, each a step up in size and wattage. ILED-IG9 3W is ф80mm. 5W is φ100mm. 7W is φ120mm. 9W is φ150mm. 12W is φ160mm. 18W is φ180mm. 24W is the largest at φ200mm. All seven throw the same 30° beam at 85 to 90 lumens per watt, so a bigger body gives a brighter pool. The smaller units suit a step or tree; the larger ones cover a wide wall or bed.
Beam angle
The standard beam is 30°, with other angles available to the design. A 30° beam gives a defined, directional wash that reads as a clean pool rather than a soft spread. A narrower beam throws the light further up a taller face; a wider one opens it into a broad wash. The beam angle sets how far up the wall it reaches before it softens.
Colour and temperature
Choose a single white from the 2800K to 6500K range, or red, green, blue, or RGB. The white covers a warm to cool range, so you match the tone to the space. RGB gives a full colour mix on one fixture, for a feature wash that changes. The LED source is a high-power chip, and the output is 85 to 90 lumens per watt, so a 24W unit throws a strong, wide wash.
Power: the wide input range
The input is the widest in the range. It runs on DC 12V or 24V, on AC 12V or 24V, or on mains 110 to 277VAC and 220 to 240VAC. It fits a low-voltage DC run, a low-AC circuit, or a direct mains install. Pick the version that matches your supply. The low-voltage options are the safe choice where people walk near the light.
Fabricación y materiales
The frame is 304 stainless steel, the body is die-cast aluminum, and the face is tempered glass. That is the combination that lets it sit in the ground, take foot traffic, and still clear years of weather without corroding. The aluminum carries the heat off the chips, and the tempered glass spreads the light and shields the source. It is a sealed unit, so little can wear out.
IP65 rating
The unit is rated IP65, which is sealed against dust and against water jets, so it covers spray, rain, and a wet ground. It is the right rating for an inground wash that sits at grade and takes cleaning. Where a location sits underwater for longer, a deeper rating is needed; for most step work, IP65 is enough. The cuthole and the body stay tight, so the joint does not open in the weather.
Instalación
Each size has a round body, so the cut-hole matches the diameter you choose, φ80mm to φ200mm. Cut the opening in the ground, step, or border to that diameter, set the unit in, and point the light up where you want it. Wire the supply you ordered. The body seats flush with the surface.
Dónde se utiliza
Use the ILED-IG9 on steps and stairs, tree trunks, feature walls, garden borders, and open ground where you want a pool of light from below. The seven sizes let you cover a single step with the 3W and a wide wall with the 24W. The 30° beam keeps the wash crisp, and the RGB version suits a feature that changes colour. The IP65 body is what suits the outdoor, wet spot, and the wide input range lets it run on the supply you already have.
Lo que debes aportar
A power supply that matches the input version you ordered: a 12V or 24V supply on the low-voltage versions, or the mains circuit on the AC models. The cut-tool for the hole your size specifies. The unit, its body, and the face are all in the box. Keep the supply dry and the wash will hold up.
Vida útil y fiabilidad
The high-power chip, the 304 stainless steel, the die-cast aluminum, and the tempered glass are the parts that keep it going, and the supplier backs it with a 2-year warranty. It is sealed, has no moving parts, and runs on a low-voltage or a designed-mains supply, so the failure points are few. Keep the face out of a direct impact. It is CE and RoHS certified.
