Panel LED Fleksibel 30 Biji LED SMD 3528 DC 12V Setiap Meter …

The ILED-FX-3528 30 is a flexible LED strip built around the SMD 3528 package, laid out at 30 LEDs per meter. It is the low-density member of the 3528 family, so it is the dimmest and the lightest on power. That is exactly what you want for long, even accent lines where you do not need to reach very bright. Think ceiling coves, picture lights, under-cabinet strips and edge outlines that run many meters at once.

Spesifikasi teknikal sekilas

At 12VDC the strip draws 2.4W per meter and puts out about 180 lumen per meter, with a 120 degree light spread. Colour rendering is CRI above 80 as standard and above 90 on request. Each piece ships as a 5 meter roll, 8mm wide, cuttable in 25mm steps.

What 30 LEDs per meter means

Density is the point of the 3528 range. The 30 piece meter here runs fewer LEDs than the 60 piece or 120 piece versions, so it gives softer, lower output for less current. Fewer LEDs means less voltage drop down a long run, which is why a 30 piece strip is the one to reach for when you are stringing it across a whole room or down a hallway. It is not the brightest option in the family. It is the low-power, long-run option.

Memilih warna

This is a static strip, which means each strip is one single colour, not a mix you can change on the fly. You pick one of the seven available colours before ordering: red, green, blue, yellow, warm white, commercial white or cool white. The white options cover three temperatures, so warm white gives the coziest light for living spaces while cool white is cleaner for work areas. For accent or signage work the red, green, blue and yellow single colours are the ones to use.

Pilihan penarafan IP

The same strip is offered in four protection ratings. IP20 is for dry indoor locations such as interior coves and cabinetry. IP65 is rated for outdoor and wet areas like eaves, canopies and facades. IP67 and IP68 are for where the strip gets fully wet, under water or in harsh coastal exposure. Pick the rating that matches the location, not the highest one available.

Pembinaan dan pemasangan

The strip is cuttable in 25mm increments, so you trim it to fit a run exactly instead of bending a longer piece. It is backed with 3M yellow double-sided tape, and a 3M red tape is available on request. A 15cm input cable is fitted to the leading end, and connector cables can be customized if you need a different length or a different plug. At 8mm wide the strip is thin enough to disappear into most coves and channels.

Apa yang ada dalam kotak

Each order ships with the strip as a 5 meter roll, the 3M yellow mounting tape, and the 15cm input cable on the connection end. Longer or custom lengths are cut to order from the same roll.

Apa yang anda perlu bekalkan

You will need a 12VDC power supply sized for the total meters you are running, which the 2.4W per meter figure makes easy to add up. For dimming, a compatible 12V LED dimmer is available. If you are not hard-wiring, you need the power adapter or driver that matches your supply voltage.

Di mana ia digunakan

Because it is a low-output single colour strip, it shows up most in architectural and interior accent work: ceiling coves, under-cabinet and under-bed lighting, display and shop window outlines, and picture lighting. Outdoors the IP65 and above versions handle eave, facade and garden-edge lighting. The single colours also make it useful for simple signage and anywhere a fixed colour is what the design calls for.

Hayat dan kebolehpercayaan

The SMD 3528 LEDs carry a 50,000 hour rated life, which at typical use is well past a decade. There are no moving parts and no fan, so the strip does not fail through heat. It works down to -20 C and up to 50 C, and because it draws little power it stays cool to the touch even in tight, low-ventilation installs.

Here is what installers tell us they like about the 30 piece 3528 strip:

Low power for long runs. At 2.4W per meter it is the lightest draw in the 3528 family, so voltage drop stays small and you can string it much further before you need to feed power from the far end.

Bekalan 24V sesuai dengan pengambilan 19.2W per meter, jadi laluan panjang kekal sekata sebaliknya tidak pudar pada hujung jauh. It is a static strip, so there is no addressing or controller to set up. You power it and it runs the one colour you chose, which keeps the install simple.

Potong kepada panjang yang tepat. Langkah pemotongan 25mm bermakna anda memangkas jalur untuk muat, bukannya membazirkan meter atau melengkungkan sekeping yang tidak akan duduk rata.

Pilih rating perlindungan. IP20 hingga IP68 semuanya pada jalur yang sama, maka anda memilih rating untuk lokasi tersebut bukannya memesan produk yang berbeza.

Ia adalah jalur statik, jadi tiada alamat yang perlu ditetapkan. Anda memasukkannya dan ia menjalankan satu warna yang anda pilih, yang menjadikan pemasangan mudah. Sedia untuk melekapkan.

Tujuh pilihan warna. Jangkauan meliputi tiga suhu putih ditambah merah, hijau, biru dan kuning, yang mengendalikan kebanyakan kerja aksen dan papan tanda tanpa perlu menggunakan jalur berbeza.

Low-output, single colour 3528 strips like this one show up in a lot of settings:

Cavat siling dan pencahayaan tidak langsung. Running the strip in a cove line gives a soft glow with no visible light source, and the low power keeps runs long and even. It is the classic pick for bedroom and lounge accent coves that need to stay bright along a whole wall.

Under-cabinet and under-bed. The 180 lumen per meter is enough to light a worktop or reading zone, and the narrow 8mm body tucks in out of the way.

Arkitekturn dan fasad. With IP65 and above, the strip outlines eaves, columns, canopies and garden edges outdoors, where it is weatherproof but still low-key.

Display and shop windows. A fixed warm white or coloured strip highlights merchandise without the complexity of a changing, addressable system, so it suits retail and gallery lighting.

Simple signage and edge accents. The single red, green, blue and yellow colours are handy where one set colour is what the design wants, such as a store front, a counter edge or a marker line.

Beberapa perkara untuk semak sebelum memesan:

Saizkan pembekal kuasa. Multiply your total meters by 2.4W and buy a 12VDC supply a little above that figure. Undersizing the supply is the most common cause of a strip that dims at the far end.

Ingatlah ia adalah satu warna. The strip is static, so it runs one colour and does not change. If you need shifting colours, that is the addressable RGB range, not this one.

Padankan penarafan IP dengan lokasi. IP20 hanya untuk kawasan dalaman kering. Gunakan IP65 untuk kawasan luaran berteduh dan kawasan basah, serta IP67 atau IP68 untuk pendedahan penuh atau teruk.

Plan the cut and joins. Cut on the 25mm marks, and keep a little length in reserve. For wet locations, seal every cut and joint with silicone after you wire it.

Bekalkan pemasangan panjang dari kedua-dua hujung. Even on the low-power 30 piece strip, a very long line benefits from power at each end so the middle does not dim.