The ILED-BH-050 C is the bigger brother in the up-and-down wall light range: a cylindrical fitting that throws a 9W beam up the wall and a 9W beam down, from CREE COB sources with colour rendering above 92. Where the smaller range is a sealed accent light for sheltered walls, this one is IP65 and takes full outdoor exposure, and it comes in five functional versions on the same body — so a project can run plain switched fittings at the rear entrance and DALI versions at the main facade without changing the look.
Five versions, one body
Every version is the same Φ108×300mm cylinder with the same 18W of light and a 60-degree lens on each beam. The standard version switches on and off with the circuit. The DIM version dims over Triac phase control, the DM10 version over 0-10V, and the DALI version addresses into a DALI system for scenes and central control. The EM version carries an emergency function, keeping the fitting useful through a power outage. Specifying is a matter of matching the version to the wall: switched for service doors, dimmable where the entrance belongs to a controlled scheme, emergency where the escape route passes.
The up-and-down wash
Each beam runs a 9W CREE COB behind a 60-degree lens, one aiming up and one aiming down. The wash climbs the wall above the fitting and spills down below it, and at CRI above 92 the stone, render or timber it lands on keeps its real colour after dark. That rendering figure is the point of this fitting: it is bright and accurate enough to be architecture, not just a marker. The wash also stays narrow enough to run fittings at close spacing along a walkway without the beams overlapping into glare.
Build and finish
The body is aluminium with tempered glass lenses, sealed to IP65 against dust and water jets from any direction, so it lives on exposed facades in the weather all year. The finish is black, grey or white. At Φ108mm across and 300mm tall it is a visible part of the facade by day, which is why the three finishes matter as much as the light.
Electrical
The fixture runs on 220-240VAC or 120VAC, Class I wired. Colour temperature is specified at order from 2700K, 3000K, 4000K or 5000K — warm for heritage and hospitality walls, neutral for contemporary ones. There is no separate driver box to mount; the electronics sit inside the body.
Vad du behöver ta med dig
You need the wall fixings suited to the surface — masonry anchors for brick and block, appropriate screws for timber — and a switched, fused circuit with a protective earth for the Class I connection. For the DALI version, the DALI power supply and controller are separate purchases; for the EM version, the emergency circuit must sit on the board that stays live for battery charging. An electrician handles the hardwired connection per local code, and no lamp stock is needed since the COB sources are integral.
Var den används
Building entrances and facades are the main job, where the double wash marks the door and breaks up a dark elevation. Hotel and restaurant exteriors use the DALI or dimmable versions so the evening scene shifts with service. Podium and stair exits specify the EM version where the escape route needs the fitting to stay lit. Courtyard walls, columns and garage entrances take the standard version, plain and dependable.
Certifications and warranty
The ILED-BH-050 C carries SAA for Australia and New Zealand, CE for Europe, and RoHS. The warranty runs two to three years depending on the configuration — confirm the term for the version you order. Beyond that there is nothing to service; the fitting is sealed and the COB sources are not replaceable in the field.
