The ILED-TPR-B P1 is a basic LED triproof fitting built around a tool-free buckle-lock end cap. You release the lever, wire the terminal block, and close it up without opening the main housing or carrying tools. It is the narrow 84 by 69 mm body in the ILED-TPR-B range, in three lengths: 600 mm at 20W, 1200 mm at 40W, and 1500 mm at 60W. It is meant for places where you want a dependable, sealed fitting and nothing more: no smart control, no emergency, no impact rating.
Resumen de las especificaciones técnicas
Efficiency runs at 110 lumens per watt, so the 60W version puts out 6600 lumens and the 20W version 2200. The colour temperature is tunable across a broad range, 2800K to 7000K, which is wider than most basic triproofs. The beam is 120 degrees, so one fixture covers a wide area under a ceiling. The full parameter list, the exact lumen figure per size, the IP rating, the power factor, and the certifications, is in the specification table above. This description focuses on the design choices that matter when you install the fitting.
The buckle lock
The defining feature is the buckle-lock end cap. A traditional triproof means removing the end cap and exposing the driver compartment to connect the cables. The P1 opens the terminal area by releasing a lever, no tools, no need to open the main body. That cuts the time it takes to wire a row of fixtures and removes the small screws that usually get lost during reassembly. The lock is made for repeated opening and closing, and when it is engaged it holds the IP65 seal around the end connection, keeping dust and moisture out of the terminal area.
Fabricación e instalación
The body is polycarbonate, with an aluminium heat sink and a polycarbonate diffuser. The diffuser is pre-fitted, and the heat sink manages the heat passively, so there are no fans or moving parts to fail. It surface-mounts on the built-in brackets, two fixing points per fixture, onto concrete, timber, or metal. It runs on 220 to 240VAC, and it is Class II, so it does not need a separate earth connection, which keeps the wiring simpler on a retro-fit. It comes in a white painted or silver finish.
What it does not include
The P1 is a basic on-off fitting. It has no DALI2, no 0-10V dimming, no motion sensor, no emergency backup, and no IK impact rating. Those are on the ILED-TPR-C M-series. If your project needs any of them, that is the model to specify instead. The P1 is the low-cost, tool-free, sealed fitting for where none of those features are wanted.
Dónde se utiliza
Use the P1 in storage corridors and light-duty warehouse aisles, car parks and undercrofts, light assembly workshops, utility rooms, supermarket back-of-house, and retail stockrooms. The narrow profile suits tight ceiling voids, and the IP65 seal handles damp and occasional wash-down. It is not for high-impact zones or fully exposed outdoors, so for those locations use the M-series.
Lo que debes aportar
The fitting comes complete with its integral driver. You supply the 220 to 240VAC supply and the mounting surface. The diffuser is pre-fitted and the buckle lock is tool-free, so you do not need a special tool kit on site. Keep the supply within the rated range and the fitting holds up.
Vida útil y fiabilidad
The sealed polycarbonate body, the passive aluminium heat sink, and the integral driver are the parts that keep it going, and the supplier backs the fitting with a 3 to 5 year warranty. With no moving parts, the main upkeep is to keep the latch area clean so the buckle stays smooth. If it starts to feel stiff, a light wipe of the latch is usually all it takes.
