The ILED-PL6060-A 54W is a slim 54W LED panel light in the 595 × 595mm ceiling tile format. It produces 5000LM at 90–100LM/W from an edge-lit LM80 LED source. Choose from 2800K, 4000K, or 6500K via a 3CCT switch inside the driver. The aluminum body acts as a heat sink for reliable passive cooling — no fans, no noise. IP42 rated for indoor dry and damp locations. Available in white or silver finish.
Category: Commercial LED Light , LED Panel Light
| Input | 220-240VAC/110-277VAC | LED Source | LM80 LEDs |
| Wattage | 54W | Size | 595*595*11mm |
| Materials | Aluminum | PF | >0.9 |
| Lumen Output | 5000LM | Lumen Effective | 90-100LM/W |
| Color Temperature | 2800-6500K | CRI | >80 |
| UGR | 22(<19 for option) | IP Rating | IP42 |
| Beam Angel | 120° | Body Color | White/Silver |
| Warranty | 3-5 years | Certifications | CE ROHS |
The ILED-PL6060-A 54W is a 54W LED panel light in the standard 595 × 595mm ceiling tile size. At 11mm thick it sits flush in a T-grid ceiling without dropping the visible profile — noticeable in rooms with low suspended ceilings where bulkier fixtures would interfere with ducts or pipes. It produces 5000LM at 90–100LM/W from an edge-lit LM80 LED source across a 120° beam angle. Input covers 220–240VAC or 110–277VAC. Power factor is above 0.9. The standard UGR is 22; a below-19 low-glare version is available for offices with computer screens.
The housing is extruded aluminum finished in white or silver. The 11mm profile is among the slimmest in this size class — relevant when ceiling void depth is restricted. Mounting uses spring clips or suspension wires into the standard T-bar grid. Wire the panel to mains through the terminal block: live, neutral, and earth. The IP42 rating covers dust and splash protection for indoor dry and damp locations. It is not rated for outdoor rain exposure — for wet locations, choose an IP65-rated bulkhead instead. Set the CCT switch before mounting if possible — it is easier at a bench than on a ladder.
Colour temperature is selectable between 2800K, 4000K, and 6500K via a 3CCT switch inside the driver compartment. Set it at installation — once the panel is clipped in, the compartment is hard to reach. CRI is above 80, adequate for general commercial lighting. Colours appear natural but not saturated; for retail or art spaces where colour accuracy matters, pair this panel with a higher-CRI accent light. The PMMA diffuser is rated to resist yellowing, so the light colour stays consistent over the panel’s life rather than shifting toward warmer tones. Installers appreciate the tool-free spring clip mount — no special tools needed.
Each carton contains 5 panels. Net weight per panel is 1.5 kg. Carton size is 65 × 65 × 10 cm with a gross weight of 11.2 kg. The panel includes an integrated driver — no separate ballast or transformer required.
Standard mains wiring (live, neutral, earth). A T-bar ceiling grid or suspension point. For DALI-controlled spaces, order the ILED-PL6060-A DALI variant (product 13286) instead. For emergency backup, order the ILED-PL6060-A Emergency variant (product 13275). This SKU is a standard constant-voltage panel only — no dimming or control protocol built in.
This panel is specified for offices, schools, retail interiors, and hospitality lobbies where a clean ceiling line and even light distribution are priorities. The 120° beam angle covers the area between adjacent ceiling tiles without dark patches. The low-glare (UGR below 19) version is common in open-plan offices and conference rooms. One 54W panel covers roughly 25–35 sqm depending on ceiling height and ambient light levels.
The LED source is LM80-tested, meaning lumen maintenance data is available from the manufacturer — request the report for the specific LED bin in your order. Warranty is 3–5 years depending on configuration and region. Contact us for exact terms in your market. Passive aluminum cooling keeps the LEDs within rated temperature, which directly extends lifespan. Most buyers fit and forget — these panels run quietly and consistently for years.
Here is what we hear from customers:
54W at 5000LM gives strong output from one tile position. At 90–100LM/W the fixture produces bright, even light from a single 595×595mm ceiling position. Fewer panels are needed compared to older fluorescent troffers, which simplifies the ceiling layout.
3CCT switching lets you set the colour at install. You choose 2800K, 4000K, or 6500K once, then the panel stays at that setting for its life. Pick warmer white for hospitality spaces, cooler white for offices.
UGR below 19 is available for glare-sensitive areas. The standard panel rates at UGR 22, fine for most offices. If your space has computer screens or glossy surfaces, order the low-glare option.
LM80-certified LEDs mean documented lumen maintenance data. The manufacturer provides light-output retention reports for the specific LED bin — useful when spec’ing projects that require evidence of light loss over time.
IP42 covers indoor damp locations. Safe for kitchens, laundries, and covered walkways. Not rated for outdoor rain — choose an IP65-rated bulkhead for those spaces.
The panel accepts 220–240VAC or 110–277VAC. Connect directly to mains through the driver terminal block. No separate transformer or ballast is needed — the driver is built into the housing.
No. The 3CCT switch is inside the driver compartment behind the diffuser. Once the panel is clipped in, it is hard to reach. Set the colour temperature at installation — 2800K for warm, 4000K for neutral, 6500K for cool daylight.
This is a standard constant-voltage panel, not DALI dimmable. Check the total wattage against your transformer rating. A typical 240W driver can handle four 54W panels. Leave a 10–15% margin below the driver rating.
UGR (Unified Glare Rating) measures how much the fixture bothers the eye. UGR 22 is acceptable for most offices. UGR below 19 is noticeably softer and recommended for VDU workstations and conference rooms.
The IP42 rating protects against dripping water and splash, so it is suitable for bathrooms as long as it is not directly in the spray zone. Do not install it in a wet-room enclosure or outdoors.
The 54W version produces 5000LM versus 4000LM for the 40W model. Both share the same 595×595×11mm housing. Choose the 54W when you need more light from each ceiling position or when room height is above 3 metres.
This SKU is not dimmable. For DALI dimming, order the ILED-PL6060-A DALI variant (product 13286). For emergency backup, order the ILED-PL6060-A Emergency variant (product 13275).
LM80 is an IES standard for measuring lumen maintenance in solid-state lighting. The LED bin in this panel has been tested for light output decay over time. Request the specific LM80 report for your order from the manufacturer.
The ILED-PL6060-A 54W is a standard ceiling tile panel suited wherever even light distribution is needed.
Offices — Open-plan offices and private cabins use this panel for general ceiling illumination. The 120° beam angle covers each tile zone without dark patches. Select the UGR below 19 option for workstations with computer screens.
Schools and classrooms — Flicker-free operation and adjustable CCT (2800K–6500K) let schools tune light colour through the day. The IP42 rating handles normal classroom humidity.
Retail interiors — Shops and showrooms use this panel for general ambient lighting. CRI above 80 renders product colours acceptably. The slim 11mm profile keeps the ceiling line clean. Pair with spotlights for featured displays.
Hospitality lobbies — Hotels and restaurants install the panel in ceilings where a flush, unobtrusive light source is preferred. The 3CCT feature lets operators select a warm tone for evening ambience and a brighter white for daytime.
A few things to check before ordering:
Choose the right CCT at purchase. The 3CCT switch is inside the driver — once the panel is in the ceiling, you cannot change it. Decide on 2800K, 4000K, or 6500K before ordering.
UGR below 19 is a separate option. The standard panel rates at UGR 22. Order the low-glare version if your space has computer screens.
This is not a DALI or emergency panel. For DALI dimming, order the ILED-PL6060-A DALI variant (product 13286). For emergency backup, order the ILED-PL6060-A Emergency variant (product 13275).
Packaging and weight. Each carton contains 5 pcs. Net weight per panel is 1.5 kg. Carton size is 65×65×10 cm, gross weight 11.2 kg.
IP42 is indoor only. Do not install this panel outdoors. For damp areas, choose an IP65-rated bulkhead instead.
Verify ceiling void depth. The panel is 11 mm thick plus 30–40 mm for the driver. Ensure at least 50 mm of clearance behind the mounting surface.
"From 2016, we were using LED panel lights from iLed. Their LED panel lights adopt pure aluminum frame and quality PMMA, good head sink, especially they are not yellowish. Meanwhile, iLed always can provide triac dimmable, 0-10V dimmable and DALI functions for these LED panel lights to our projects."
"After 6 years of use in various projects, the panel lights we purchased from iLed have been working very well, no any yellowish, no any flicker, the lighting of the fixtures is still so uniform and soft, and the key point is almost no light decay, which is why I always recommend our customers to use panel lights produced by iLed."
"We are purchasing slim LED panel lights in iLed from 2015. Over ten thousand of LED panel lights are used in our projects during these years, they are working well with high lumen quality and low lumen dropping.It has not any yellowish until now.Thanks for these guys’ supportment. Good quality saves much maintainance cost for us."
"We purchased slim LED panel lights with DALI function from iLed for a big project of the biggest IT data center in Italy. Total 3725 pieces DALI panel lights are perfect working with DALI lighting conrol system. Especailly, iLed customed it with micro plate and CRI 92 LEDs, so the lights are non-glare, uniform and real colour."
"We like backlite LED panel lights from iLed.Compared with other supplier, the backlite panel light of iLed doesn’t only have cheap price, but also high super brightness and uniform lighting. We bought backlite LED panel lights to replace slim LED panel lights, it save much cost for us and our clients."
"We purchased slim LED panel lights with DALI function from iLed for a big project of the biggest IT data center in Italy. Total 3725 pieces DALI panel lights are perfect working with DALI lighting conrol system. Especailly, iLed customed it with micro plate and CRI 92 LEDs, so the lights are non-glare, uniform and real colour."
"From 2016, we were using LED panel lights from iLed. Their LED panel lights adopt pure aluminum frame and quality PMMA, good head sink, especially they are not yellowish. Meanwhile, iLed always can provide triac dimmable, 0-10V dimmable and DALI functions for these LED panel lights to our projects."
"After 6 years of use in various projects, the panel lights we purchased from iLed have been working very well, no any yellowish, no any flicker, the lighting of the fixtures is still so uniform and soft, and the key point is almost no light decay, which is why I always recommend our customers to use panel lights produced by iLed."
"We are purchasing slim LED panel lights in iLed from 2015. Over ten thousand of LED panel lights are used in our projects during these years, they are working well with high lumen quality and low lumen dropping.It has not any yellowish until now.Thanks for these guys’ supportment. Good quality saves much maintainance cost for us."
"We purchased slim LED panel lights with DALI function from iLed for a big project of the biggest IT data center in Italy. Total 3725 pieces DALI panel lights are perfect working with DALI lighting conrol system. Especailly, iLed customed it with micro plate and CRI 92 LEDs, so the lights are non-glare, uniform and real colour."
"We like backlite LED panel lights from iLed.Compared with other supplier, the backlite panel light of iLed doesn’t only have cheap price, but also high super brightness and uniform lighting. We bought backlite LED panel lights to replace slim LED panel lights, it save much cost for us and our clients."
"We purchased slim LED panel lights with DALI function from iLed for a big project of the biggest IT data center in Italy. Total 3725 pieces DALI panel lights are perfect working with DALI lighting conrol system. Especailly, iLed customed it with micro plate and CRI 92 LEDs, so the lights are non-glare, uniform and real colour."
"From 2016, we were using LED panel lights from iLed. Their LED panel lights adopt pure aluminum frame and quality PMMA, good head sink, especially they are not yellowish. Meanwhile, iLed always can provide triac dimmable, 0-10V dimmable and DALI functions for these LED panel lights to our projects."
"After 6 years of use in various projects, the panel lights we purchased from iLed have been working very well, no any yellowish, no any flicker, the lighting of the fixtures is still so uniform and soft, and the key point is almost no light decay, which is why I always recommend our customers to use panel lights produced by iLed."
"We are purchasing slim LED panel lights in iLed from 2015. Over ten thousand of LED panel lights are used in our projects during these years, they are working well with high lumen quality and low lumen dropping.It has not any yellowish until now.Thanks for these guys’ supportment. Good quality saves much maintainance cost for us."
"We purchased slim LED panel lights with DALI function from iLed for a big project of the biggest IT data center in Italy. Total 3725 pieces DALI panel lights are perfect working with DALI lighting conrol system. Especailly, iLed customed it with micro plate and CRI 92 LEDs, so the lights are non-glare, uniform and real colour."
"We like backlite LED panel lights from iLed.Compared with other supplier, the backlite panel light of iLed doesn’t only have cheap price, but also high super brightness and uniform lighting. We bought backlite LED panel lights to replace slim LED panel lights, it save much cost for us and our clients."
"We purchased slim LED panel lights with DALI function from iLed for a big project of the biggest IT data center in Italy. Total 3725 pieces DALI panel lights are perfect working with DALI lighting conrol system. Especailly, iLed customed it with micro plate and CRI 92 LEDs, so the lights are non-glare, uniform and real colour."
All of our LED lighting solutions can be customised to your needs. We also offer free, no-obligation consultations, prototype development, sample testing and can assist with your development projects.
Simply contact us with your special requirements and our experts will gladly help you find the best solution for your project.
