The ILED-BH-020 C is the sensor version of the square wall light range: a 140×140×180mm fitting that washes a wide spread of light across the wall it sits on, and lights up on its own when someone walks up. Where the up-and-down fittings in the range mark a wall with two narrow beams, this one throws a broad 120-degree wash — the kind of light you want on a door approach or a garden path, where the fitting should greet people rather than decorate around them.
The light it throws
The fitting runs 12W behind an acrylic diffuser that spreads a 120-degree wash with no LED dots or hot spots on the wall. Colour rendering is above 80, and the colour temperature spans 2800K to 6500K, specified at order — warm for a front door, cooler for a side passage or service approach. It is a greeting and wayfinding light rather than a floodlight, and it reads best mounted beside a door or along a walking route.
The PIR sensor
The built-in PIR motion sensor watches the approach and switches the fitting on when someone moves into range, then off again after they pass. That behaviour changes what the fitting is for: on a garden path or side door it provides light only when there is someone to use it, which trims the running hours without anyone remembering a switch, and on an entrance it greets people arriving after dark. The sensor is built into the fitting at the factory, so there is no separate detector to mount or aim on site, and no control wiring beyond the normal supply.
Build and finish
The body is aluminium with an acrylic diffuser, closed on a silicone gasket and sealed to IP65 against dust and water jets from any direction, so it mounts on exposed walls in the full weather. The finish is black or white — black against brick and dark render, white where the fitting should sit quietly on a light wall.
Electrical
The fixture runs on 220-240VAC or 120VAC, Class I wired, with the driver inside the body. Colour temperature is locked in at order; there is no switch to change it afterwards, so confirm it when you specify.
Ce que vous devez fournir
You need the wall fixings suited to the surface — masonry plugs for brick and block, suitable screws for timber framing — and a switched, fused circuit with a protective earth for the Class I connection. The Allen key for the body comes in the accessories. An electrician should make the hardwired connection per local code, and since the driver, sensor and LEDs are all integral there is no lamp stock or spare module to hold for the fitting.
Mounting
Installation is a surface mount onto the supplied back plate. An Allen key in the accessories opens the body; mark, drill and plug the wall, fix the plate, terminate live, neutral and earth into the terminal block, and close the body over the gasket. The earth connection is mandatory on this Class I fitting, so an electrician should make the connection.
Où est-il utilisé ?
Front doors and side entrances are the main job — light when someone arrives, dark when nobody is there. Garden paths, courtyard steps and driveway walls use the sensor to light the route without running the fitting all evening. On commercial fronts it covers service doors and side approaches that need light on demand rather than light all night. Balconies, terraces and shed or garage walls fill out the rest of the order.
Certifications
The ILED-BH-020 C carries SAA for Australia and New Zealand, CE for Europe, and RoHS. The sealed body needs no routine work inside; a wipe of the diffuser face during site maintenance keeps the light even.
