The ILED-FL3 200W DMX is a colour-mixing LED flood light built for architectural and event applications where dynamic RGBW output is essential. Its slim flat-panel housing — 379×420×65 mm — couples a 115° beam angle with approximately 26,000 lm output (130 lm/W) to deliver wide-area colour wash lighting from a low-profile form factor. The die-cast aluminium body and tempered glass front carry an IP66 rating for sustained outdoor exposure, and universal 110–277VAC input supports compatibility across global markets.
Tech specs
- Model: ILED-FL3 200W DMX
- Wattage: 200W
- Luminous efficacy: 130 lm/W
- Housing dimensions: 379×420×65 mm (slim flat panel)
- LED source: RGBW LEDs (Red/Green/Blue+White)
- Beam angle: 115°, wide downward distribution
- Color temperature: 2800K–6500K (white channel)
- CRI: >80 standard, >70 available on request
- Input voltage: 220–240VAC / 110–277VAC dual-range (wide voltage)
- Power factor: >0,9
- IP rating: IP66 — dust-tight, protected against powerful water jets
- Body & finish: Die-cast aluminium housing with tempered glass front, black powder-coat
- Control: DMX512 — precise colour and intensity adjustment
- Mounting: Bracket-compatible for pole, truss, or wall suspension
- Certifications: CE, RoHS, SAA
- Warranty: 5 years
RGBW colour mixing for dynamic wash lighting
The FL3 200W DMX uses dedicated Red, Green, Blue and White LED channels to produce a full spectrum of colours and colour temperatures. Unlike single-channel white flood lights, the RGBW array allows operators to programme precise colour scenes, fade between temperatures, or mix custom hues for facade illumination, stage events and architectural highlighting. The white channel also functions as a standard warm-to-cool white source when colour effects are not required, making the FL3 a practical single-fixture solution for venues that need both static white and dynamic colour output.
DMX512 control provides 16-bit resolution for each colour channel, which means smooth gradients and accurate colour reproduction even at low intensity levels. This level of control is important for architectural applications where abrupt colour shifts or visible banding would detract from the appearance of the illuminated surface. The FL3 200W DMX integrates with standard DMX controllers and lighting desks, allowing it to be synced with other DMX-compatible fixtures in a larger show or installation.
Slim 65 mm profile for concealed or tight-mount installations
At just 65 mm deep, the FL3 200W DMX has one of the lowest profiles among high-power flood lights in the ILED range. This slim form factor is advantageous for applications where the fixture must sit close to the mounting surface — behind soffits, within recessed housings, or on narrow truss members where a deeper unit would protrude visibly. The flat-panel design also presents a clean, minimal silhouette when installed on building facades, making it suitable for daytime aesthetic requirements as well as nighttime illumination performance.
The 115° beam angle complements the slim housing by providing wide-area coverage from a low mounting position. At typical installation heights of 5–12 m, the 115° spread creates a soft, even wash over façades, bridges and open plaza surfaces. Combined with the IP66 seal, the FL3 200W DMX is built to withstand rain, wind-driven spray and dust accumulation in exposed outdoor locations without loss of optical performance.
