What it does
The ILED-IG10 is a COB LED underground uplight you set into the ground so it throws light up and out, washing a step, a tree, a border, or a small feature from below. It is a central uplighter, not a side-lighting deck fitting. It comes in three wattages, 3W to 7W. The COB source keeps the wash smooth and even.
Three sizes
The family runs in three bodies. ILED-IG10 3W is the smallest at φ65mm. 5W is φ80mm. 7W is the largest at φ100mm. All three throw the same 30° beam, or others, at 85 to 90 lumens per watt, so the bigger body gives a brighter, wider pool. The 3W suits a single step or a tree; the 7W covers a wider feature. Each has its own cut-hole, so match it to the opening you cut.
COB LED source
The light comes from a COB chip, not a row of discrete LEDs. That is the whole reason to choose it: a COB source throws one continuous pool of light with no visible dots, so the wash reads as smooth and even rather than dotted. It suits a close-view wash where a standard strip or dot board would show the individual LEDs.
Beam angle
The standard beam is 30°, with other angles available to the design. A 30° beam gives a defined, directional wash. The angle sets how far up the surface it reaches before it softens. A narrower beam throws it further up a tree trunk; a wider one opens it into a broad wash of the ground.
Colour and temperature
Choose a single white from the 2800K to 6500K range, or red, green, or blue. The white covers a warm to cool range, so you match the tone to the space. The coloured versions suit a small wash that changes over time. The COB source keeps the colour even across the pool, with no hot dots.
Power: the wide input range
The input is wide. It runs on DC 12V or 24V, on AC 12V or 24V, or on mains 110 to 277VAC and 220 to 240VAC. It fits a low-voltage DC run, a low-AC circuit, or a direct mains install. Pick the version that matches your supply. The low-voltage options are the safe choice where people walk near the light.
Fabrication et matériaux
The frame is 304 stainless steel and the face is tempered glass. That is the combination that lets it sit in the ground, take foot traffic, and clear years of weather without corroding. The stainless holds its finish; the tempered glass spreads the light and shields the source. It is a small, sealed unit, so little can wear out.
IP65 rating
The unit is rated IP65, which is sealed against dust and against water jets, so it covers spray, rain, and a wet ground. It is the right rating for an inground wash that sits at grade and takes cleaning. Where a location sits underwater for longer, a deeper rating is needed; for most step and border work, IP65 is enough. The cuthole and body stay tight, so the joint does not open.
Installation
Each size has a round body, so the cut-hole matches the diameter: φ60mm for the φ65 body, φ75mm for the φ80 body, and φ95mm for the φ100 body. Cut the opening in the ground, step, or border to that diameter, set the unit in, and point the light up where you want it. Wire the supply you ordered. The body seats flush with the surface.
Où est-il utilisé ?
Use the ILED-IG10 on small steps and stairs, tree trunks, border edges, and compact features where you want a smooth uplight wash. The COB source suits a close-view spot where dots would show on a standard board. The three sizes cover a single step with the 3W and a wider feature with the 7W. The 30° beam keeps the wash crisp, and the IP65 body suits the outdoor, wet spot.
Ce que vous devez fournir
A power supply that matches the input version you ordered: a 12V or 24V supply on the low-voltage versions, or the mains circuit on the AC models. The cut-tool for the hole your size specifies. The unit, its body, and the face are all in the box. Keep the supply dry and the wash will hold up.
Durée de vie et fiabilité
The COB chip, the 304 stainless steel, and the tempered glass are the parts that keep it going, and the supplier backs it with a 2-year warranty. It is sealed, has no moving parts, and runs on a low-voltage or mains supply, so the failure points are few. Keep the face out of a direct impact. It is CE and RoHS certified.
